Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateTrusted Garage Door Opener Repair for Henderson Homeowners
A garage door opener that grinds, reverses for no reason, or refuses to move at all is more than an annoyance. It can strand your car in the driveway on a 110-degree afternoon or leave your home unsecured overnight. Most opener repairs in Henderson run between $120 and $320, and our techs carry the common parts on the truck, so the fix often happens in one visit. We’ve worked on thousands of openers across the Las Vegas Valley since opening as Brock Garage Doors Henderson. Call (775) 458-8864 and a live person answers, day or night.
Garage Door Opener Installation
Garage Door Opener Installation means mounting a new or replacement opener unit to your garage ceiling, connecting it to the door, and setting the force, limits, and safety sensors. You need it when the old motor is beyond repair, when you want a quieter belt drive instead of a noisy chain drive, or when you want battery backup for Henderson’s monsoon-season power outages. Brock Garage Doors Henderson installs openers at $250 to $550 depending on drive type, horsepower, and whether we’re reusing existing brackets and wiring. Every install includes sensor alignment, travel-limit calibration, and a written 365-day guarantee.
What Affects Installed Price
The main variables are drive type and horsepower. Chain drives cost less but run louder. Belt drives cost more and make sense for attached garages where the master bedroom sits above. A 3/4-horsepower unit handles heavy double doors better than a 1/2-horsepower unit.
Installation Day What to Expect
We arrive in the scheduled window, not a four-hour block. The old unit comes down, the new one goes up, and we test the safety reverse, the sensors, and both remotes before we leave. The site is swept clean and the price you approved is the price you pay.
Styles & brands we work with
Garage Door Opener Replacement
Garage Door Opener Replacement is the job of swapping a dead or failing opener for a new unit, rather than patching the old one with piecemeal repairs. You’re at this point when the motor hums without moving, the logic board burns out, or the gear assembly strips and the cost to repair approaches the cost of new equipment. Replacement typically runs $250 to $550 in Henderson, including removal of the old unit and full setup of the new one. If your opener is under 10 years old, we’ll tell you honestly whether repair makes more sense. If it’s older, we’ll quote you the replacement price in writing before anything comes off the ceiling.
When Repair Beats Replacement
Bad remotes, loose chains, misaligned sensors, and worn belts rarely justify a full replacement. We’ll tell you if a $150 repair buys you another three to five years. That’s the only number that matters in the decision.
When Replacement Is the Smarter Call
A motor that’s seized, a logic board that’s fried, or a unit built before 2005 without safety eyes means replacement is usually the better path. The quote we hand you covers the unit, labor, removal, and cleanup. No “miscellaneous” line items appear later.
Garage Door Remote Programming
Garage Door Remote Programming links your handheld remotes, keypad, and vehicle HomeLink buttons to the opener’s receiver using the right frequency, rolling code, and protocol. You need it when a remote stops working after a battery swap, when you buy a used car and want the old owner locked out, or when a new keypad won’t sync. This service typically falls at the lower end of our $120 to $320 repair range. Brock Garage Doors Henderson programs remotes for LiftMaster, Chamberlain, Genie, and Clopay units, and we clear the old codes so every previous remote is wiped from memory.
Why Programming Fails
Dip-switch era openers, mismatched frequencies, and worn-out remote circuit boards are the usual culprits. Some universal remotes just won’t hold a code on newer rolling-code systems. We’ll tell you in the first five minutes whether the remote is fixable or needs replacing.
Keypad and HomeLink Setup
Exterior keypads need a personal PIN, not just a sync. Vehicle HomeLink systems often require a second button press sequence inside the car. We walk through both while you’re standing at the garage door so it works before we leave.
Garage Door Opener Battery Replacement
Garage Door Opener Battery Replacement swaps the backup battery inside the opener’s motor housing or the small flat batteries in your remotes and wireless keypads. You need it when the wall button works but the remote doesn’t, or when your opener beeps every few seconds to signal a dying backup battery. The replacement itself is usually under $100, though it’s often bundled into a $120 to $320 service call if we’re addressing other issues. We stock batteries for LiftMaster and Chamberlain openers, plus the common remote batteries, so we can handle it in one trip.
Backup Battery vs. Remote Battery
The backup battery lives inside the motor unit and keeps the door working during a power outage. It beeps when it’s failing and lasts about two to three years. Remote and keypad batteries are simple coin or 12-volt cells, but you’d be surprised how many “opener failures” turn out to be a dead 9-volt in a keypad.
What We Check Alongside the Battery
While replacing a backup battery, we’ll check the charging circuit and the opener’s power draw. A battery that won’t hold charge is sometimes a symptom of a failing logic board, not just age. We’d rather catch that now than have the opener die during a Henderson power blip.
Garage Opener Maintenance
Garage Opener Maintenance is the preventive service that keeps your opener running quietly and reliably, mostly by tightening hardware, lubricating the rail, checking the safety reverse, and testing the force settings. Most Henderson homes should have it done once a year, especially before the hot summer months when motors work harder. It typically costs $120 to $240. Brock Garage Doors Henderson treats maintenance as an inspection with correction, not a quick spray-and-go. We test every function and show you exactly what we found.
What a Maintenance Visit Includes
We check the drive chain or belt tension, the gear sprocket on chain-drive units, the safety sensors at both sides of the door opening, and the force sensitivity. We lubricate the rail, hinges, and rollers where warranted, and we tighten the mounting brackets that rattle loose over time.
Henderson-Specific Wear Patterns
Dust from the dry desert air works into the gear housing and shortens chain and gear life. We see more worn gears in Henderson than in coastal cities. If your opener is noisy, it’s usually the gear getting ground down by fine dust and heat, which maintenance can slow but not reverse.
Garage Door Opener Not Working
Garage Door Opener Not Working is the most common call we take in Henderson, and the cause is almost always one of five things: a dead battery, a knocked-out sensor, a tripped GFCI outlet, a stripped gear, or a burned-out logic board. The fix averages $120 to $320, and we diagnose it over the phone when symptoms are clear before we even dispatch a truck. If the opener hums but the door doesn’t move, it’s likely the gear. If it’s completely silent, it’s likely power. Either way, a technician from Brock Garage Doors Henderson can get it sorted.
Common Causes of Sudden Failure
First, check the outlet. In Henderson, a garage circuit that shares space with a freezer or powertool can trip the GFCI and kill the opener. Next, look at the safety sensors near the floor. If one blinks or is knocked sideways, the opener will click but refuse to close.
What Our Techs Check First
We start with power at the unit, then signal from the wall button versus the remote, then the safety sensor circuit, then the motor and gear assembly. That sequence isolates the problem in under 15 minutes on most calls. We’ll quote the exact repair before we touch anything.
Garage Door Motor Replacement
Garage Door Motor Replacement replaces the electric motor inside the opener housing when it seizes, overheats, or no longer generates enough torque to lift the door. It’s needed when the opener hums and the door stays put, when the motor trips its own thermal overload after one cycle, or when a burning smell comes from the unit. Expect to pay $250 to $550, since in most cases the practical fix is a full opener replacement rather than a motor-only swap. Our techs will tell you straight: some motors are serviceable, most are not worth the labor to rebuild.
Motor Replacement vs. Full Opener Replacement
Replacing just the motor on a 12-year-old unit is false economy. You’d still have an old logic board, old wiring, and no warranty on the old housing. A full replacement gets you a new unit, new parts, and our 365-day guarantee in writing.
Signs Your Motor Is Failing
Listen for a grinding noise under load. Watch for the door going up slower than it used to. If the opener runs for a few seconds then stops, the motor is overheating. None of these fix themselves. Acting early can prevent a motor seizure with the door half open.
Brands We Service
Our technicians are trained on eight major opener brands. We service LiftMaster and Chamberlain extensively, and we stock the common logic boards, gears, and safety sensors for both. These two share the same parent company, but their programming sequences and part numbers differ, and we know both cold.
We also repair Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor units. Whether you have a screw-drive Genie from the early 2000s or a belt-drive Clopay installed in 2021, we can get the right part and the right fix applied. If you have a different make, call us before you assume it’s dead. Many obscure brands use Chamberlain-compatible internals.
See the difference
Before
After
Before
After
Before
AfterSigns You Need a Pro Right Now
- Your opener runs but the door doesn’t move. The motor is turning but the drive gear or belt isn’t engaging, which means a stripped gear or a broken belt. Running it more makes it worse.
- The door reverses immediately after touching the floor. The safety sensors or force settings are out of adjustment. Left alone, it becomes a security issue because the door won’t stay closed.
- You hear grinding or chattering from the motor housing. This is usually the gear assembly chewing itself apart. The fix is one gear kit, but running it longer can damage the motor and push you into replacement.
- The opener trips its own fuse or overload repeatedly. Continuous overload points to failing capacitors or a motor winding problem. This is a fire hazard and a strong reason to stop using the opener until it’s checked.
- The door starts and stops in fits while opening. Intermittent operation points to a failing logic board or cracked solder joints. It often works again in an hour, then fails at the worst possible time.
Our Process, Step by Step
- 1
You call, a human answers. Our phones are answered live 24/7 in Henderson. We get your address, the symptoms, the opener brand and age if you know it, and we give you a straight service window.
- 2
We arrive and listen. The tech asks what’s been happening, when it started, and what you’ve already tried. He’ll test the wall button, the remotes, and watch the door run before opening any tool bag.
- 3
We hand you a written price. Before any repair starts, you get a written price. That’s the number on the invoice, not an estimate with caveats. You approve it, we begin. You don’t, we leave and you owe nothing for the trip.
- 4
We fix it and test it thoroughly. The tech repairs the opener and runs the door through a full cycle test, including safety reverse and sensor alignment. We check the remotes and keypad before we call the job done.
- 5
We leave the garage clean and the guarantee in writing. The site is swept, the old parts are offered to you or discarded, and you receive a written 365-day guarantee. If it fails in that window, we return at no charge.
How Much Does Garage Door Opener Repair Cost in Henderson?
A typical garage door opener repair in Henderson runs $120 to $320 depending on the failed part and how long it takes to access. A gear kit replacement on a chain-drive unit usually lands between $150 and $250. A new logic board runs closer to $250 to $320. Sensor alignment or a simple remote programming job sits at the low end, around $120 to $150. Every price is quoted in writing before work begins.
What moves the price: the age of your opener, the brand, whether parts are in stock on the truck, and drive type. Chain-drive units are cheaper to fix than belt or screw drives. Older units may need a discontinued part sourced, which adds days but not necessarily cost. You avoid overpaying by asking for a written quote before the work starts and refusing broad verbal estimates. Our free estimate includes the diagnostic, the parts, the labor, the trip, and cleanup. The number we quote is the number you approve, and the invoice matches it.
Our Service Area Near Henderson
Brock Garage Doors Henderson serves all of Henderson, including Green Valley, Anthem, Whitney, and Paradise. We also run calls to Boulder City, Summerlin South, and Southern Highlands. Our typical response time across the valley is same-day on most repairs. For garage door opener work in the neighboring communities, see Garage Door Opener Repair in Boulder City and Garage Door Opener Repair in Summerlin South. You can also start at our home page for general service information.
Serving Henderson, NV - Our Local Coverage Area
We’re based in the Henderson area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked Questions About Garage Door Opener Repair in Henderson
Garage door opener repair is the service of diagnosing and fixing a malfunctioning opener, including the motor, gear, belt, chain, safety sensors, logic board, remotes, and keypad. It can mean anything from a quick sensor realignment to a gear replacement or motor swap. We give you a written price for the exact repair before we begin.
Most repairs take between 45 minutes and two hours. Gear kits, sensor alignments, and battery replacements are usually done in under an hour. Logic boards and motor replacements may take up to two hours, and we carry the common parts on our trucks so most jobs are completed same-day.
You’ll pay $120 to $320 for most repairs in Henderson, depending on the failed part and opener type. The lowest-cost jobs are remote programming and sensor alignment. Gear and logic board replacements fall in the middle and upper end. Every quote is written before work starts. Call (775) 458-8864 for an exact price.
Yes, we service LiftMaster, Chamberlain, Genie, Clopay, and several other brands. We stock the common parts for LiftMaster and Chamberlain units, including gears, sensors, and logic boards. If we don’t have the part on the truck, we source it quickly and keep you updated.
Yes, we run same-day service across Henderson and nearby areas like Green Valley, Anthem, and Paradise, and we also offer Garage Door Opener Repair in Boulder City. A live person answers the phone 24/7, and we’ll give you an honest window when you call. For emergencies where the door won’t close, we prioritize your call because an open garage is a security risk.
Every repair from Brock Garage Doors Henderson is covered by a written 365-day guarantee. If the same repair fails within a year, we return and correct it at no charge. This is not a verbal promise. It’s in writing on your invoice before you pay.
Clear the area around the opener and the garage door track so the tech can work safely. If you know the opener brand or model, have it ready. And if the door is stuck open, unplug the opener and don’t try to force the door down by hand. A trained technician will handle it without making the problem worse.
Schedule Your Garage Door Opener Repair Service in Henderson Today
If your opener is acting up, call Brock Garage Doors Henderson at (775) 458-8864. We’ll give you a straight answer, a written price, and a repair that’s covered in writing for a full year. A live person answers around the clock, and we serve Henderson and the surrounding neighborhoods with same-day service. Your estimate is free, and the price you approve is the price you pay.
Written by Wade Mercer, Owner at Brock Garage Doors Henderson, serving Henderson since 2001.