Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateGarage Door Before & After in Henderson, NV
Photos tell the truth faster than any promise. When a Henderson homeowner asks what we actually do, we show them. Below are real job narratives from the neighborhoods we work in every week: the spring that snapped at 6 a.m. in Green Valley, the panel that buckled in an Anthem garage, the opener that gave up in a Summerlin-adjacent subdivision. Each one ended the same way: written price first, work done right, one-year guarantee in hand.
Styles & brands we work with






Recent Transformations
Torsion Spring Replacement, Green Valley North
Before
AfterThe homeowner called at 5:40 a.m. because the door wouldn’t budge. The left torsion spring had sheared clean through, leaving the opener to fight the full weight of the door on its own. We quoted $285 over the phone, arrived by 7:15, and replaced both springs as a matched pair. By 8:30 the door lifted smoothly and quietly, balanced within a half inch from floor to header. The repair is covered in writing for 365 days; if either spring fails in that window, we return at no charge.
Off-Track Door with Bent Roller, Macdonald Ranch
Before
AfterThis door had jumped the lower track after a bent roller bound against the rail and kept climbing anyway. The homeowner noticed the scrape marks before the door fully derailed, which is rare; most people don’t see it until the door hangs at an angle. We replaced the roller, swapped both cables while we were in there, and re-squared the track to the wall brackets. Total was $265, written and approved before the first wrench came out. The door runs true now, with fresh nylon rollers on both sides.
Garage Door Opener Motor Replacement, Inspirada
Before
AfterThe old opener was a 2006 Chamberlain chain-drive that had started grinding and reversing mid-cycle. The logic board was fine; the motor itself had burned a winding. We quoted a new LiftMaster 84501 belt-drive at $520 installed, including reprogramming the remotes and keypad. The difference is striking: the old unit rattled the kitchen wall when it ran; the new one is quiet enough that the homeowner’s dog doesn’t wake up anymore. Opener work carries the same 365-day guarantee as any repair we do.
Broken Cable with Drum Replacement, Whitney Ranch

The cable on the right side had frayed to about three strands of wire holding on, which meant the door was one cycle away from dropping hard on the concrete. Homeowners in Whitney Ranch see this more than most: the heat and dry air here accelerates cable wear on older doors that get used four or five times a day. We replaced both cables and the right-side drum for $220, re-tensioned the springs, and ran the door through twenty full cycles with a clamp meter on the motor to confirm the load was even. Most cable repairs run $150 to $275, depending on cable type and drum condition.
Section Panel Replacement, Anthem Country Club

A golf cart incident, as the homeowner put it. The bottom panel was caved in about six inches, and the door wouldn’t seal against the slab, which meant heat and dust were getting in all day. We measured the panel, ordered a color-matched replacement from the original manufacturer, and had it installed in nine days. The door closes flush now, and the new bottom seal keeps the afternoon wind from pushing dust under the threshold. Total was $640, including the panel, labor, and new weatherstripping.
Full Door Conversion: Chain-Drive to Belt-Drive with New Springs, Seven Hills

This homeowner had a 1999 wooden door on a chain-drive opener that sounded like a freight line every time it cycled. The springs were also original, which is a timeline nobody should push past twenty years. We converted the whole assembly: new torsion springs rated for the door weight, a Chamberlain belt-drive opener, and nylon rollers all around. The door now lifts with one finger’s worth of force and runs at about a third of the volume. Written price before work: $1,150. The garage is quieter than the living room now.
Want Results Like These?
If your garage door is making noise, hanging crooked, or refusing to lift, call Brock Garage Doors Henderson at (775) 458-8864. A live person answers day or night, and you’ll get a written price before any work starts. Every repair is covered in writing for a full year. If it’s not done right, we make it right at no charge.
Written by Wade Mercer, Owner at Brock Garage Doors Henderson, serving Henderson since 2001.
See the difference
Before
After
Before
After
Before
After